Product Name: Brass compression fitting Male Elbow
Size: 16 × 1/2’’; 16 × 3/4’’; 20 × 1/2’’; 20 × 3/4’’; 20 × 1’’; 25 × 1/2’’; 25 × 3/4’’
25 × 1’’; 32 × 3/4’’; 32 × 1’’; 32 × 1-1/4’’
Surface Treatment: Natural; Nickel Plated
Compression fittings are popular because they do not require soldering, so they are comparatively quick and easy to use. They require no special tools or skills to operate. They work at higher pressures and with toxic gases. Compression fittings are especially useful in installations that may require occasional disassembly or partial removal for maintenance etc., since these joints can be broken and remade without affecting the integrity of the joint. They are also used in situations where a heat source, in particular a soldering torch, is prohibited, or where it is difficult to remove remains of water from inside the pipe which prevent the pipe heating up to allow soldering.
Warranty time: 5 years
Offer sample: Available
FOB Price(Ningbo): USD 0.2- USD 3.7
Delivery time: in 20 days after down payment
Port: Ningbo Port or Shanghai Port
Packing:Plastic bag+Inner box+ Export Carton+4 Packing Belts
Three- and four-way have an L- or T-shaped hole through the middle. The different combinations of flow are shown in the figure. It is easy to see that a T valve can connect any pair of ports, or all three, together, but the 45 degree position which might disconnect all three leaves no margin for error. The L valve can connect the center port to either side port, or disconnect all three, but it cannot connect the side ports together.
Multi-port ball valves with 4 ways, or more, are also commercially available, the inlet way often being orthogonal to the plane of the outlets. For special applications, such as driving air-powered motors from forward to reverse, the operation is performed by rotating a single lever four-way valve. The 4-way ball valve has two L-shaped ports in the ball that do not interconnect, sometimes referred to as an "×" port.